Ultimate magazine theme for WordPress.

Samsung Galaxy J1 SM-J100MU Flash File Stock Rom 4.4.4

Samsung Galaxy J1 SM-J100MU Flash File

www.androidduniya.com reminds readers it will not be held responsible for any damage to the device during or after installation of Samsung Galaxy J1 SM-J100MU Flash File using Odin. Readers are advised to proceed at their own risk because of hardware faults.

Requirements to install Samsung Galaxy J1 SM-J100MU Flash File

    [adinserter block=”16″]

  1.  Enable OEM to unlock (If applicable):
    • Firstly, Go to Settings » About phone » and tap “Build number” seven times to enable “Developer options”.
    • Secondly, Go back to the main Settings page, scroll to the bottom and select “Developer options” from there.
    • Thirdly, Under Developer options look for Enable OEM unlock checkbox/toggle and make sure you Check it or turn it ON.

Related: Samsung Galaxy Grand Prime SM-G530H

How to Install Samsung Galaxy J1 SM-J100MU Flash File

  1. Boot your Samsung Galaxy J1 SM-J100MU into Download mode
    • Firstly, Switch off your phone.
    • Secondly, Press and hold “Home + Power + Volume down” buttons for a few seconds until you see a warning screen.
    • Thirdly, Press Volume Up on the warning screen to accept it and boot into Download mode.
  2. Once your Samsung Galaxy J1 SM-J100MU is in download mode, connect it to the PC via USB cable. The Samsung Odin window on PC should detect the phone and show an”Added!!” message.
  3. Now, extract the .zipped Samsung Galaxy J1 SM-J100MU Flash File file you have downloaded to get the Odin flashable.tar file inside. Skip this step if you already have a .tar file of the Samsung Galaxy J1 SM-J100MU Flash File.
  4. Click on the AP tab on Odin window and select the .tar.md5 file from the SM-J100MU Flash File file that you have downloaded or can download it from the given below Link. Note: don’t play with any other options on the screen. Only you have to connect your Samsung Galaxy J1 SM-J100MU device and select the PA tab.
  5. Click the Start button on Odin and wait for it to finish the process. Once it has finished successfully, you’ll see a pass message on the Samsung Odin screen.
  6. Finally, the device will automatically reboot after Odin complete the flashing. Now disconnect your Samsung Galaxy J1.



Note: All product names, logos, and brands are the property of their respective owners. All company, product and service names used on this Blog are for identification and learning purposes only.

You might also like

Leave A Reply

Your email address will not be published.